Friday, June 08, 2012
An overview of observations that were heard or seen weather or not factual nor conclusive have crossed paths during the past year of LENR. These can be noted now along a path to design a reactor equivalent to the technology involved.
Heat transfer from the reaction chamber through the copper tube and into the supporting framework of the reactor support needs to be controlled as to allow heat to build up within the (fuel) reaction chamber and or released swiftly, and allowed to flow into a directed specific area at any given time with an unlimited sliding scale of reference as to direction and speed of thermal heat energy encompassed within the reactor assembly.
Within our reactor there are three bands of cooling, the inner, outer, and mid bands which are polar arrays of ports with individual control for coolant (fluid) flow. When a chamber is running hot the three bands are separately controllable, as far as cooling fluid volume and can regulate singularly each direction the heat needs to transfer from or held into the source fuel chamber while in operation.
Hydrogen loading seems to be another variable factor toward efficiency of the LENR reaction and a need for pulsating the hydrogen, like a wave providing pneumatic physics in conjunction with thermal transfer. The wave exerts it's potential force onto the outer circumference of a fuel used and my preference is the ISOTAN 44 (Ni + Cu + Mn) of which I believe that was used by all successful LENR experimenters at this time. To much variable exists with the mixing of the powders and it seems that was meant to slow everyone else down attempting to promote LENR research, keep them busy with all the obstacles and that's a good reason for making the statements that if the reactor is torn apart it self destructs. They should have re worded it to be more technically correct. "If you tear the reactor apart the fuel rods disappear and no matter how hard you try to make the reaction work the fuel needs to be replaced and the fuel is essentially the reactor. Like purchasing a car with only one tank of gas and then after that's done gone the car becomes useless unless someone else supplies you with fuel.
Our reactor has the capability to maintain 10,000psi hydrogen pressure and pulsate it during the reaction process through a simple pre cup orifice chamber used commonly with gas/solid fuel reactions. This process also allows a pre heating of the hydrogen and directly dependent on the dimension, orifice size, and the area within the pre cup chamber. It is concluded that the higher the hydrogen loading pressure the more depth of penetration into the nano skeleton matrixes that have been grown onto the outer circumference of the ISOTAN 44 fuel rods. Obvious with the fuel rods contemplated is a consistency in exact percentages of elements used and that means to grow the nano structures is simply a current induced for a specific amount of time and a standard set for starting experiments.
Also the fuel wires used for the Celani et al. experiments were of nano size and the resistance nominally is around 1500